Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Model #
77W
Hawthorne Chair
Assembly Instructions
Congratulations!
This fine piece of furniture will make a handsome
addition to your home. For the best results, start by
reading both the Assembly Instructions and
Finishing Hints before you begin your project.
For normal household use only.
recommended for commercial use.
Do not climb or stand on this piece of
furniture.
P.O. Box 2827
Eugene, OR 97402 USA
Service Policy:
which are defective, missing or damaged
during assembly. Please contact Whittier
Wood Products customer service department
directly (by phone, fax, mail or email) for
replacement parts.
Hours:
Our friendly customer service staff
can be reached Monday-Friday 7:00 a.m. to
5:00 p.m. (Pacific Time). A message can be
left 24 hours a day, 7 days a week.
To Order:
Provide the complete furniture
model number (upper left corner of this
page), part letter, production code, quantity
needed, reason for replacement and your full
name and address along with a telephone
number in case we need to contact you.
Parts ship from our Eugene, Oregon factory
within 1 or 2 business days from the time
we receive the request. Please allow 5-10
business days for delivery.
Outside U.S. or Canada: 541-687-0213
Outside U.S. or Canada: 541-687-0213
Fax: 541-687-2060 • Email: [email protected]
Fax: 541-687-2060 • Email: [email protected]
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Mail: P.O. Box 2827 • Eugene, Oregon 97402, U.S.A.
Read both the Assembly Instructions and Finishing
Hints completely before beginning.
Store the parts: 1) in their box; 2) in a dry place; 3) in
temperatures ranging from 40° to 90°. (Not on a cold,
possibly damp, cement floor.)
Inspect your furniture periodically for any loose glue
joints or screws, or any other problem which may
be affecting the stability of your furniture. Tighten or
repair as needed.
Production Code:
We will replace any parts
Rev. 3/06
Tabla de contenido
loading

Resumen de contenidos para Whittier Wood Furniture Hawthorne 77W

  • Página 1 Model # Hawthorne Chair Assembly Instructions Service Policy: We will replace any parts which are defective, missing or damaged during assembly. Please contact Whittier Wood Products customer service department directly (by phone, fax, mail or email) for replacement parts. Hours: Our friendly customer service staff can be reached Monday-Friday 7:00 a.m.
  • Página 2 77 Hawthorne Chair — Parts List Before beginning assembly, check that the quantities of the parts received match those on the parts list below. A — Lower Back — Qty. 1 B — Back Spindle — Qty. 5 J — Seat — Qty. 1 CC —...
  • Página 3 77 Hawthorne Chair — Parts Diagram Right Front Leg Side Stretcher Front Stretcher Left 2¾" Black Front Screw Front #8 x 1¾" Apron Right Back Side Pan Head Apron Screw Back Stretcher #8 x 1¾" Pan Head Wood Wood Screw Button Dowel Side...
  • Página 4: Tools Required

    77 Hawthorne Chair ASSEMBLY INSTRUCTIONS TOOLS REQUIRED: Phillips Head Screwdriver, Wood Glue, Rubber Mallet or Padded Hammer. IMPORTANT: READ GLUING HINTS BEFORE ASSEMBLING! FIG. 1 1) Spread a thin layer of glue in the five holes in the top edge of the Lower Back (A). Insert the Back Spindles (B) into the holes.
  • Página 5 Square end Angled end 3) Glue two Dowels (P) in each end of the Front Apron (G) and the Side Aprons (H). Lay the aprons on the bottom of the Seat (J) in their approximate positions. See FIGURE 3. Note: The Front Apron (G) is square on both ends. The Side Aprons (H) are square on the front end and angled on the back end to fit against the back legs.
  • Página 6 FIG. 6 7) Lay the Seat (J) face down on a clean protected surface, with the back of the seat hanging over the edge. Center the leg assembly on the seat and making sure that the seat remains in contact with the back legs, fasten in place with 2¾"...
  • Página 7 Modelo # Silla Hawthorne Instrucciones para Armar Normas para obtener servicio: Reemplaza- remos las piezas que tengan defectos, falten o se dañen durante el armado. Sírvase comunicarse con el departamento de servicio al cliente de Whittier Wood Products directamente (por teléfono, fax, correo o e-mail) para obtener piezas de repuesto.
  • Página 8: Instrucciones Para Armar

    77W – INSTRUCCIONES PARA ARMAR HERRAMIENTAS NECESARIAS: Destornillador Phillips, mazo de caucho o martillo, pegamento. 3) Coloque (con pegamento) dos espigas de unión (P) en cada IMPORTANTE: extremo de la falda delantera (G) y de las faldas laterales ¡LEA LOS CONSEJOS SOBRE (H).
  • Página 9 No. de modèle Chaise de Politique de service : Nous remplacerons toutes Hawthorne les pièces défectueuses, manquantes ou endom- magées pendant le montage. Veuillez contacter Instructions de Montage directement le service clientèle de Whittier Wood Products (par téléphone, fax, courrier ou e-mail) pour obtenir les pièces de remplacement.
  • Página 10: Instructions D'assemblage

    77W – INSTRUCTIONS D’ASSEMBLAGE OUTILS NÉCESSAIRES : Tournevis cruciforme, maillet en caoutchoue ou marteau, colle. IMPORTANT : 3) Collez deux goujons (P) dans chaque extrémité du ta- AVANT DE PROCÉDER À blier avant (G) et des tabliers latéraux (H). Posez les L’ASSEMBLAGE, LISEZ LES tabliers sur le dessous du siège, dans leurs positions CONSEILS DE COLLAGE !

Tabla de contenido