Tabla De Contenido; Design Information; Models Available; Product Dimensions And Clearances - Monogram ZV750 Instrucciones De Instalación

CONTENTS
Design Information
Models Available ........................................................... 3
Product Dimensions ...................................................... 3
Advance Planning
Ductwork Planning ....................................................... 4
Wall Framing for Adequate Support ............................. 4
Advance Planning ........................................................ 4
Installation Preparation
Duct Fittings .................................................................. 5
Power Supply ................................................................ 6
Tools and Materials Required ....................................... 6
Remove the Packaging ................................................ 7
Check Installation Hardware ........................................ 7
Determine Installation Height ........................................ 8
Installation Instructions
Installation - Vented to the Outside ........................ 9-13
Step 1, Install Framing for Hood Support...................... 9
Step 2, Install Mounting Brackets................................ 10

MODELS AVAILABLE

Model ZV750
Model ZV755
These hoods may be installed to vent to the outdoors,
or they may be installed for recirculating operation. All
necessary parts for recirculating operation are supplied
with the hood. No kits required.
• These vent hoods can be installed over any 30" or 36"
Monogram electric or gas cooktop except Monogram Professional cooktops or ranges larger than 30".
PRODUCT DIMENSIONS AND
CLEARANCES
The vent hood must be
installed 24" minimum,
and 30" maximum above
the cooking surface.
NOTE: Installation
height should be
measured from the
cooking surface to the
lowest part of the hood.
31-10724-7

Design Information

24" Minimum
30" Maximum
36" Minimum
Step 3, Install the Hood ............................................... 10
Step 4, Install Duct Bracket ......................................... 11
Step 5, Connect Ductwork .......................................... 12
Step 6, Connect Electrical ........................................... 12
Step 7, Install Duct Cover and Utensil Rods ............... 13
Step 8, Install Filters .................................................... 13
Step 9, Finalize Installation ......................................... 13
Installation - Recirculating .................................... 14-18
Step 1, Install Framing for Hood Support.................... 14
Step 2, Install Mounting Brackets................................ 15
Step 3, Install the Hood ............................................... 15
Step 4, Assemble Deflector and Connector ................ 16
Step 5, Size Duct Piece .............................................. 16
Step 6, Install Air Deflector Assembly ......................... 16
Step 7, Connect Electrical ........................................... 17
Step 8, Install Duct Cover and Utensil Rods ............... 17
Step 9, Install Filters .................................................... 18
Step 10, Finalize Installation ....................................... 18
• Reversible duct covers accommodate recirculating
operation.
• The telescopic duct covers conceal the ductwork
running from the top of the hood to the ceiling.
• The supplied duct cover is sized to reach ceiling
heights up to 9' or more, depending on the installation.
See the table on page 8.
35-3/8" (excluding utensil rods)
36-1/2" (including utensil rods)
ZX7510SPSS Duct Cover Accessory
This accessory is available for installations with ceiling
heights above 9' to 10' and higher. See the table on page 8.
The duct cover accessory must be on-site with the hood
at the time of installation.
*Height
to Ceiling
8-1/4"
27-1/2"
658Dia1A
3