Over-Voltage Protection; Flash Patterns - Soundoff Signal mpower EMPS2QM Serie Manual Del Usuario

with Clear Duty™ Technology

OVER-VOLTAGE PROTECTION

When an over-voltage condition is detected, the module will flash an over-voltage warning pattern of 50mS ON/950mS OFF to alert of the over-voltage condition and protect the electronics from damage due to heat/voltage.
THERMAL COMPENSATION PROTECTION
The LED module is designed to provide maximum power output while providing protection to the electronic components by reducing the output power at extreme temperatures.
SYNC 2
Synchronizing the flashing of multiple light modules is accomplished by connecting the Green wires of different light modules together. Up to 24 light modules can be connected for synchronized flashing. All light module flash patterns must be set to the
same flash pattern # to ensure proper operation. Refer to the Sequence Type section in Set-Up Table (page 8) to setup light modules to flash in alternate or simultaneous flash pattern. NOTE: Will NOT work with non-Sync 2 products such as Ghost,
LED3, and 4 wire Intersector. WILL WORK with Sync 2 products nFORCE Secondary Lights, nFORCE FIT and 5 wire Intersector Lights.

FLASH PATTERNS

SINGLE
PATTERN # DUAL COLOR TRI-COLOR
COLOR
1 QUINT
2 WARP
3 INTER-CYCLE
4 DOUBLE
5 QUAD
6 POWER PULSE
7 ROAD RUNNER
8 Q-SWITCH
STEADY-BURN / ROADRUNNER
9 (SEQUENCE TYPE 1: STEADY BURN, SE-
QUENCE TYPE 2: ROADRUNNER)
STEADY-BURN DRIVER TITLE 13 QUAD
10 (SEQUENCE TYPE 1: STEADY BURN, SE-
QUENCE TYPE 2: TITLE 13 QUAD)
11 QUAD 2
12 DOUBLE 2
13 RANDOM 1
14 RANDOM 2
1.800.338.7337 / www.soundoffsignal.com
6
®
mPOWER 9.16