Led Indicators; Connectors And Buttons - Axis T8646 Manual De Instrucciones

LED Indicators

LED
Color
POWER Unlit
Green
Amber
Red
Unlit
COAX POE
Green
Amber
Red
Unlit
LINK/ACT
Green
Amber
Red

Connectors and Buttons

For specifications and operating conditions, see page 10.
Bus Connector
The bus connectors are the physical interfaces to the video encoder chassis that provide network
and power for the blade.
BNC Connector
Connect a 75 Ohm coaxial video cable; the recommended maximum length is 250 m (800 ft).
Indication
No backplane power.
Steady: Backplane and front power ok.
Flashing: Backplane power ok. No front power.
Flashing: Front power too low or too high.
Flashing: Self test fail.
No device unit detected or PoE over coax not required.
Steady: PoE over coax enabled to device unit and camera.
Short blink: PoE over coax enabled to device unit. No PoE to camera.
Steady: Approaching power limit.
Steady: Power limit reached.
Flashing: PoE disconnected due to overload.
Short blink: Short circuit, check for cable fault or incompatible
equipment.
No device unit detected.
Steady: Device unit connected, 100Base-T link to camera.
Flashing: Device unit connected, 100Base-T link activity.
Short blink: Device unit connected, no network to camera.
Steady: Device unit connected, 10Base-T link to camera.
Flashing: Device unit connected, 10Base-T link activity.
Data rate low, cable distance at limit.
9
AXIS T8646