Axxess AW-INCH1 Manual De Instalación página 3

Installing the AW-INCH1
With the key in the off position
• Connect either the LD-BX-CH1 or LD-BX-CH2 harness into the
interface, and then to the wiring harness in the vehicle.
Note: If using the ASWC-1, connect it after you initialize and test the
AW-INCH1, with the key in the off position.
®
AW-INCH1
Initializing the AW-INCH1
Attention! If the interface loses power for any reason, the following steps will
need to be performed again. Also, if installing an ASWC-1 connect it after you
initialize and test the interface/radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait
until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key
to the off position, disconnect the interface, check all connections,
reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position.
Test all functions of the installation for proper operation, before
reassembling the dash.
3