Clicker CLT1 Manual De Instrucciones

CLICKER
Universal Garage Door Opener Remote Control
The Clicker remote can be programmed to operate up to 2 garage
door openers or gates, including different brands. All programming
is done using the:
• Brand switch
• Transmitter DIP switch
• Transmit push buttons A and B, and LED indicator
Preparation
Determine the BRAND of the existing garage door opener or
handheld remote controls. If all remote controls are lost, the
BRAND is located on the ceiling mounted motor unit or on the
receiver near the flexible wire antenna. Proceed to the correct
section for your BRAND.
NOTE: If programming to more than one opener, after
programming button "A", determine the brand of the second garage
door opener. Follow the instructions pertaining for that particular
brand to program button into "B".
ON
UP Position is ON
DOWN Position is OFF
1 2 3 4
ON
UP Position is ON
DOWN Position is OFF
1 2 3 4 5 6 7 8 9
NOTE: Use pen or small screwdriver
to move dip switches.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or
transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER
USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
When the remotes range is diminished, operation is intermittent, or
the LED dims, replace the battery. Memory is not lost when the
battery is removed. NOTE: Dispose of old batteries properly.
Motor Unit
& Receiver
Wall Mounted
Control
Remote
Control
Button A
LED
Button B
10 1112
Brand Switch
Dip Switch
Battery
Slide battery door
down & Remove
Model No. CLT1
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving gate or
garage door:
CAUTION
• ALWAYS keep remote controls out of reach of children. NEVER permit
children to operate, or play with remote control transmitters.
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
Stanley, Multi-Code, Linear, Moore-O-Matic
I Determine specific brand and circle above.
Step 1
I Open existing remote to expose code switches.
I Set brand switches on Clicker remote.
I Proceed to Step 2.
STANLEY
MULTI-CODE
LINEAR/MOORE-O-MATIC
Genie 9 and 12 Code Switches
I Open existing remote; determine if there
Step 1
are 9 or 12 code switch settings.
I Set brand switches on Clicker remote.
I Proceed to Step 2.
GENIE 9
GENIE 12
Step 2
Existing Remote
➡
Step 3
Press and hold both buttons
for 5 seconds or until LED
begins to flash.
Step 4
When LED flashes, release both buttons.
Step 5
While the LED is still flashing, press the button
you wish to operate the opener (your choice).
Step 6
Programming is complete, to test, press the
button selected to activate garage door.
NOTE: IF PROGRAMMING DOES NOT WORK TRY
REVERSING THE DIP SWITCH SETTINGS (Turn ON to
OFF and OFF to ON).
OFF OFF OFF OFF
➡
ON OFF OFF OFF
OFF ON OFF OFF
➡
OFF OFF ON OFF
ON OFF ON OFF
Clicker Remote
Match existing dip
switches. Set extra
➡
dip switches off.