Assembly - EASYHOME EE-3186A Manual De Usuario

Ultrasonic Humidifier

ASSEMBLY

Before Each Use
CHECK HUMIDIFIER PLACEMENT - Place the Humidifier on a non-metallic, lint
free, waterproof, level surface for best performance. This is to help disperse the
mist in the air and prevent it from being knocked or tipped over.
CHECK WATER LEVEL SENSOR – Make sure that the water level sensor is
secured properly. Refer to "cleaning and maintaining water level sensor" on page
12 for instructions on how to assemble the water level sensor.
CHECK FAN VENT –
This fan vent is located on the bottom of the
humidifier. The purpose of the Fan Vent is to
blow the cool mist through the vapor outlet
slots. It is important that this part is kept
clean and free of obstructions. We
recommend checking the fan vent before using
this item (i.e. lint, paper).
Do not place humidifier on top of a towel, or a
carpeted surface. The fan vent on the bottom
may become blocked, and overheat the
humidifier.
CAUTION:
DO NOT operate the humidifier without water in the water tank.
DO NOT plug in the power supply cord with wet hands; electric shock
could happen.
Be sure the humidifier is switched to OFF (O) and the humidifier is unplugged
from the electrical outlet.
Select a location for your humidifier on a flat surface approximately 4 inches
away from a wall.
DO NOT place the humidifier on a finished floor or near furniture which can be
damaged by moisture or water. Place on a water resistant surface.
DO NOT place humidifier on top of a towel, or a carpeted surface. The air vent
on the bottom may become blocked, and overheat the humidifier.
AFTER SALES SUPPORT
888-367-7373
________
[email protected]
ASSEMBLY SEMBLY
5