Tool it Flip Flap Manual Del Usuario página 3

The welding helmet FLIP-FLAP complies with EEC directives 89/686 CEE. This confirmity is established in compliance with EN 175, EN 166, EN 168 and EN 379.
This welding helmet is delivered ready for use. For your protection, please read carrefully these instructions and consult with a qualified instructor prior to operation.
BEFORE WELDING
-Check that the welding helmet is in good condition and headband adjustment.
-Check whether the front cover lens, the front frame and filter are inserted and fixed in place. In case of anomalie, please proceed to its reconditionning.
-Make sure that the protection films on both screens are removed.
-Check that the protection level matches your welding processes. Please refer to the following chart to help your choice (cf. welding process board)
OPERATION
1
PRECAUTIONS
• The welding helmet is suitable for use with virtually all welding processes except Oxy-Acetylene welding, laser welding and gas welding.
• Standard protective screens must be installed on both inside and outside surfaces of the module. Failure to use protective screens may constitute a safety hazard or result
in irreparable damage to the module.
HEADBAND ADJUSTMENT
3
MAINTENANCE
• Inspect your welding helmet FLIP-FLAP regularly.
• The welding helmet must not fall down.
• Do not put any heavy tools/objects in or on the helmet in order not to damage the filter or the protective screens.
• The deterioration of the filter or its protective screen can reduce the vision field or the protection level. Replace the damaged parts.
• Do not use any tools or other sharp objects to remove any components of filter or helmet. Doing so may damage filter or helmet preventing proper function, possibly cau-
sing injury or cancellation of the warranty.
• Clean the filter with a clean cotton or with a special rag for lens.
• Clean and change protective screens on a regular basis.
• Clean the inside and the outside of the helmet with a neutral disinfectant product.
• Do not use any solvent.
WARNING
• Use the welding helmet only for eye and face protection against harmful ultra violet and infrared radiation, sparks and spatter from welding.
• This product will not protect you against serious impact hazards such as, fragments of grinding wheels or abrasive discs, stones, or other grinding tools, explosive devices
or corrosive liquids (non exhaustive list). Appropriate protection must be used where these hazards exist.
• The hairband may cause allergies to sensitive people.
• The opto-electronic filter of the FLIP-FLAP is not waterproof and will not work properly if it has been in contact with water.
• Application temperature of the filter is from -5°C to +55°C.
• Storage temperature of the FLIP-FLAP is from -20°C to +70°C.
EN
2
Clear shade
Dark shade
Filter dimension
Reaction speed
Power supply
Weight
Field of vision
Applications
Warranty
Application temperature
Storage temperature
1
The FLIP-FLAP is equipped with a headband which can be adjsuted in multiple ways
to suit the welder: width, height (1), longitudinal inclination (3) and adjustment (2).
2
The FLIP-FLAP helmet can be used in two positions:
1- Visor up; for general works i.e. grinding (not suitable for welding).
2- Visor down; for welding work - Shade 11 screen..
0
11
110x90x10 mm
Manual
no
425gr
97x80mm
MMA 25>150 TIG 25>175 MIG-MAG 25>200
1 an
-5°C / + 55°C
-20°C / + 70°C
3