Troubleshooting Guide - Taylor 8123 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

7. The weight is displayed for approximately 30 seconds before switching off, or press and hold the
"q" button for 3 seconds to switch off manually.
8. Note: A weight reading may be reset to zero by pressing the "q" button. When the weight is
removed, the scale will show a negative number. To reset the scale to zero, press the "q" button.
TO CHANGE MEASUREMENT UNITS
Your scale is set to weigh in pounds. To switch between measurement units:
1. Press the "q" button to switch the scale on. The display shows "
showing zero.
2. When "8888" appears, press the "q" button to switch between pound (lb), kilogram (kg) or stone
(st) units of measurement (1 stone = 14 pounds).
ACCURACY & ALLOWANCES
Some factors affecting accuracy need to be allowed for:
• If the strap is pulled while taking a zero reading or the luggage touches yourself or an obstacle
during weighing this can affect the accuracy.
• Your scale rounds up or down to the nearest increment. If you take two readings and get different
readings, the weight lies between the two.
• Your scale readings may not match the airline check-in desk due to manufacturing tolerances.
• After a flight allow the scale to return to room temperature before use. For these reasons we
recommend your luggage weighs at least 1.2lb/500g less than your airline allowance, this should
also allow you to take your luggage scale with you.
ADVICE FOR USE & CARE
• Do not exceed the 110 lb / 50 kg / 7 stone 12 lb maximum weight capacity.
• Clean your scale with a damp cloth. Do not use chemical cleaning agents.
• Do not use scale if the strap or buckle show any signs of fatigue.
• Treat your scale with care – it is a precision instrument. Do not drop it.
• Do not dispose of batteries in fire. Batteries may explode or leak. Remove the battery if the scale
will not be used for a long period of time.

TROUBLESHOOTING GUIDE

If you experience any difficulty in the use of your scale:
• Check that the battery is correctly fitted.
• Check that you have selected your preference of pounds, kilograms or stones.
• If when you use the scale there is no display at all or if "
battery.
• This scale is designed to read weights between 1.2 and 110 lb / 500 g and 50 kg/ 1.2 lb and 7 st 12
lb. To prevent damage, do not place more than 110 lb / 50 kg/ 7 st 12 lb on it.
• If "EEEE" is displayed the scale has been overloaded. Remove the weight immediately; otherwise,
permanent damage could occur.
" then "8888" before
" or "Lo" is displayed – try a new
3
Tabla de contenido
loading

Tabla de contenido