Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5
operaTion
After setting up the battery, the collar
remains on standby for 2 minutes to
allow you time to attach the collar on
your dog.
At the 1st bark, a beep sound is emitted.
If a 2nd bark is detected within 30 seconds,
a beep sound and a low stimulation of
short duration are emitted.
If a 3rd bark is detected within 30 seconds, a
beep sound and a low stimulation of long
duration are emitted.
If a 4th bark is detected within 30 seconds,
a beep sound and a strong stimulation of
short duration are emitted.
If a 5th bark is detected within 30 seconds,
a beep sound and a strong stimulation of
long duration are emitted.
If your dog stops barking during 30 seconds,
at the next bark, the collar will start its
operating cycle from the beginning (beep
sound only).
After being activated 5 times in quick
succession, the collar will automatically
go into safety mode for 2 minutes before
restarting itself normally.
replacing baTTery
Due to greater use during your dog's
training, the first battery may not last as
long as replacement batteries.
Replace the battery as follows:
- Unscrew the battery cover using a coin.
- Remove the old battery.
- Insert the new battery (Lithium 3-V
CR2) paying attention to follow polarity
indicated on the collar (ref. Diagram 1).
- Retighten the battery cover using a coin. A
beep sound is emitted indicating the collar
is ready for use. If you do not hear any
beep sound when retightening the battery
cover, remove the battery immediately
from its housing. Check the polarity before
trying again.
NOTE: WheN ChANgINg The BATTeRy, TheRe CAN RemAIN
SOme pOWeR IN yOUR COLLAR. IN ThAT CASe, The COLLAR
DOeS NOT emIT ANy Beep SOUND WheN yOU ReTIghTeN
The BATTeRy COVeR AfTeR INSeRTINg The BATTeRy.
TO mAke SURe IT OpeRATeS CORReCTLy AND ThAT The
BATTeRy IS CORReCTLy INSTALLeD, See § CheCkINg The
DeVICe OpeRATeS pROpeRLy.
changing The conTacT
poinTs
Two different length of contact points
are supplied. The length of the contact
points must be sufficient to have proper
contact with the dog's skin, enabling the
device to operate correctly (proper barking
detection and correct transmission of the
stimulations).
If you have a long-haired dog and the short
contact points fitted to the collar in the
factory are inadequate, remove and replace
them with the long ones supplied with
the kit.
Carefully tighten them manually (do not
use a tool).
checking The Device
operaTes properly
you can check that your collar is functioning
properly at any time using the following
procedure:
- Before doing so, make sure the collar
is turned Off (battery removed from its
housing).
- Attach each wire of the neon test lamp
under each contact point (unscrewing
them lightly and retightening them so
as to pinch the test lamp wires under the
contact points).
- Turn On the collar (warning: after
activating the collar, it remains in stand-
by for 2 minutes).
- make a streaked object (ex. knife with
teeth and isolated sleeve) slide on the bark
detection contact point (ref. Diagram 1).
- The collar should emit beep sounds and
the test lamp should light.
- Before disconnecting the test lamp, make
sure the collar is turned Off (battery
removed from its housing).
collar aDjusTmenT
Collar adjustment is very important. In fact,
this setting determines the proper barking
detection and the correct transmission of
the stimulations.
The strap should be adjusted so that the
contact points come right into contact with the
dog's skin:
- If the strap is too loose, the collar will not
operate properly. moreover, the collar is
likely to move and repeated friction can
irritate your dog's skin.
- If the collar is too tight, the dog will have
breathing difficulties.
The strap is properly adjusted when you
can insert two fingers between the strap
and your dog's neck. If necessary, replace
the short contact points with the long ones
supplied with the kit (ref. § Changing the
contact points).
DO NOT lEAvE ThE COllAr mOrE ThAN 8 hOUrs
pEr DAY ON YOUr DOG. rEGUlArlY ChECK YOUr
DOG's NECK. If IrrITATIONs AppEAr, rEmOvE ThE
COllAr UNTIl All sIGNs Of sKIN IrrITATIONs hAvE
DIsAppEArED.
cauTions for use
- This device is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision
or instruction concerning use of the
appliance by a person responsible for their
safety.
- Children should be supervised to ensure
that they do not play with the appliance.
- Before using the device, we advise you to
have your dog checked by a vet to ensure
he is fit to wear a collar.
- We recommend to start using the collar
with dogs 6 months or older.
- Do not use the collar with dogs that are
not in good physical shape (i.e. cardiac
6
Tabla de contenido
