Marmitek Speaker Anywhere 200 Manual Del Usuario página 6

OPERATION
Switching ON
1. Turn on the audio source (TV, PC, Radio, CD-/MP3-/MP4-/DVD player) to which the
transmitter is connected. The signal LED on transmitter will light up (Green).
2. Select the L/M/R selector on the speaker receivers, one to L(eft) and the other to R(ight)
for the best stereo reception.
Note: In case the audio device only provides Mono audio signal, select the L/M/R selector
to M(ono) for the best mono reception.
3. Turn on the ON/OFF VOLUME button on the speaker and adjust the volume to the desired
level.
Tipp: for crystal clear sound, put the volume of the audio source higher and adjust the
volume of the speakers to the desired level.
4. For the best audio reception, you need to tune the set. Therefore put the speakers and
transmitter together (max 7meters in-between). Push the "AUTO TUNING" button. When
the button is pressed, frequency tuning starts automatically and it stops when a signal is
detected. The POWER / STEREO LED will change from red to green.
Whenever you find frequency jam, move your channel switch from one channel to the
other channel (there are two channels for selection) on the back of the transmitter, and
then press the "AUTO TUNING" button on the speaker again.
5. The BASS BOOST button can be used to enhance the bass sound. Turn bass/boost effect
ON simply by pressing the button down, and pressing it once again to OFF.
6
Max. 7 meters
For tuning only
© MARMITEK