Installation With Adhesive Strips; Operation; Set Value Balance (Offset) - Alpha IP RTA 61001-N1 Manual Del Usario

5.2.3 Installation with adhesive strips

Depending on the ground, installation can be performed using the supplied dou-
ble-sided adhesive tapes. Installation is possible on different grounds, as e. g. ma-
sonry, furniture, tiles or glass.
If the installation is done with adhesive strips, the installation surface must
1. Select an appropriate installation position. be smooth, level, undamaged, clean, and free from grease and solvents.
2. Remove the protective foil from one side of the adhesive strip.
3. Fix the adhesive strip on the back side of the installation bottom in the recesses
provided for this (see page 4 fig. 2c).
4. Remove the protective foil from the other side of the adhesive strip.
5. Align the device horizontally to the desired position and press it on.

6 Operation

The target temperature is set manually on a scale from 0 to 5 by turning the setting
wheel (E) to the left or to the right.

6.1 Set value balance (offset)

Since the temperature is measured at the room control unit, it may be warmer or
cooler in another position in the room. The deviation can be corrected via a set value
balance of -2 K to 2 K in 0.5 K increments.
1. Remove setting wheel (E). There is a scale for the balance on the inside of the
setting wheel (E) (see page 5 fig. 5)
2. Insert the set point correction limiter (F) to the desired place in the setting wheel
(E).
Operation
35