Cleaner Assembly; Carton Contents - Dirt Devil Quick & Light FD50005 Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

CARTON CONTENTS

CARTON CONTENTS
A. Handle
B. Cleaner Base
C. Midsection
D. Dirty Water Tank
E. Clean Water Solution Tank
F. Screws (4)
G. Nuts (4)
Remove all parts from carton and identify each item
shown.
Make sure all parts are located before disposing of
packing materials.
ASSEMBLY- BASE & MIDSECTION
Using a Phillips screwdriver
1.2 Stand base in upright position. Push midsection onto
base by aligning tabs on the backside of midsection with
the pockets on the backside of base.
One at a time, place nut into recess located on the back of
the left, right and middle back of the base. While holding
nut in place, insert screw through front of midsection and
tighten.
Repeat this process with the remaining two (2) nuts and
screws
• NOTICE •
Make sure the power cord is out of the way to
avoid pinching.
ASSEMBLY- HANDLE
1.3 Slide upper handle down
onto unit. Place nut into
recess in back of upper
handle. While holding nut in
place, insert screw through
front of upper handle and
tighten. Route cord above
upper cord hook and snap
into cord clip on upper
handle.

1. CLEANER ASSEMBLY

1. VACUUM ASSEMBLY
1.3
1.1
1.1
A
C
1.2
UPPER HANDLE
MIDSECTION
TABS
5
5
E
B
F
D
G
UPPER
CORD
HOOK
CORD
BASE
Tabla de contenido

Solución de problemas

loading

Tabla de contenido