Rubik's BT10 Manual De Instrucciones página 10

Charging the BT10 (built-in 3.7 V rechargeable battery)
1. Turn off the BT10 before charging.
2. Connect the BT10 to a PC/laptop/Mac or any 5 V USB adaptor (not included) using the USB cable
included.
3. The red LED turns ON during charging and turns OFF when fully charged.
4. Unplug the USB cable after it is fully charged. It takes about 2 hours to fully charge the speaker.
5. The red LED flashes when the power is low (<21%) and makes a beeping sound.
6. The speaker turns off automatically if it is inactive for 15 minutes.
Pairing the BT10 with Bluetooth-enabled devices (mobile phones, tablets,
etc.)
1. Please keep the speaker and mobile phone within 1 meter of each other.
2. Hold the Power button for 3 seconds to turn on the speaker; the blue/red LED flashes quickly,
indicating that the speaker is ready for pairing.
3. Switch on the mobile's Bluetooth function and search for Bluetooth devices, then select "BT10"
from the Bluetooth device list. As per the pairing process, you may need to enter a password
(0000) depending on the Bluetooth version on your device.
4. After successful pairing, select "BT10" from the Bluetooth device list and press "connect".
5. After successful connection, the LED changes to solid blue.
6. Hold the Power button for 3 seconds to turn off the speaker.
Note:
1. If pairing is not successful, turn off the speaker and re-pair it again.
2. After successful pairing, paired devices will remember each other. Unless pairing information is
deleted, there is no need to pair when using it next time.
3. Pair with new device by following steps 1 - 5 above after disconnecting the existing pair.
Re-connecting to a paired device
If the speaker does not automatically connect to the last used device, then you will need to select it
manually from the list of devices on your mobile phone.
Hands-free – incoming calls
1. Press the "Hands-free" button to answer the phone call and press it again to end the call.
2. Press and hold the "Hands-free" button to enter pairing mode.
Play/Pause
Press Play/Pause to pause and press again to play.
- EN 3 -