Troubleshooting - Procom Heating PCK80T El Manual Del Propietario

WARNING: Never service heater while it is plugged in, operating
or hot. Severe burns and electrical shock can occur.
WARNING: High voltage! Unplug heater before servicing.
FAULT CONDITION
Motor does not start eight sec-
onds after heater is plugged in.
Motor starts and runs but
heater does not ignite.
8

TROUBLESHOOTING

POSSIBLE CAUSE
1. No power to heater.
2. Thermostat setting is too
low.
3. Bad electrical connection
between motor and ignition
control assembly or igni-
tion control assembly and
power cord.
4. Binding pump rotor.
5. Defective ignition control
assembly.
6. Defective motor.
1. No fuel in tank.
2. Pump pressure incorrect.
3. Dirty fuel filter.
4. Obstruction in nozzle.
5. Water in fuel tank.
6. Bad electrical connection
between ignitor and ignition
control assembly.
7. Defective ignitor.
8. Defective ignition control
assembly.
www.usaprocom.com
REMEDY
1. Check circuit breaker in
electrical panel.
2. Turn thermostat knob to a
higher setting.
3. Check all electrical connec-
tions. See Wiring Diagram,
page 15.
4. If fan does not turn freely,
see Pump Rotor, page 14.
5. Replace ignition control as-
sembly. See Ignition Control
Assembly, page 13.
6. Replace motor.
1. Fill tank with kerosene.
2. See Pump Pressure Ad-
justment, page 11.
3. See Fuel Filter, page 11.
4. See Nozzle Assembly,
page 13.
5. Drain and flush fuel tank
with clean kerosene. See
Storing, Transporting, or
Shipping, page 7.
6. Check electrical connec-
tions. See Wiring Diagram,
page 15.
7. Replace ignitor, see page 12.
8. Replace ignition control as-
sembly. See Ignition Control
Assembly, page 13.
160177-01C