Tool Checks - Grip Rite GRTFR83 Manual Del Operador Y Lista De Piezas

Tool operates, but no
fastener is driven.
Tool won't operate -
nail jammed in tool
nose, preventing tool
from operating.
Tool leaks air.

TOOL CHECKS

Keep your nailer in top working condition by checking it daily. See your
Grip-Rite® dealer for service if part or operating problems are found.
Never use a malfunctioning tool - it could result in serious injury.
Workpiece Contact & Trigger
Check workpiece contact for proper operation before each use. Work-
piece contact must move freely and return to extended position when
lifted from workpiece. Trigger must operate freely.
Daily Inspection
• Check for broken, damaged, or excessively worn parts, and repair
or replace as needed.
• Check for air leaks at trigger, cap, and nose. Disconnect tool
from air supply immediately if leaks are present, and see dealer
for service.
• Make sure all screws are tightened securely.
FASTENER DRIVING PROBLEMS
Check magazine for jammed fastener. Clear
jam and reload magazine. Check nail strip for
smooth feeding in magazine.
Remove jammed fastener. Check magazine
for incorrect, bent, or loose fasteners, and
discard. Reload using Grip-Rite™ nails.
Check for source of leak, and tighten fittings
and screws as required. Discontinue using
tool if air leaks at trigger area or from cap
exhaust. Contact your dealer.
TROUBLESHOOTING
19