Unit Placement; Feed Water Valve And Tee Fitting; Drain Clamp Installation - Genpar NURFILTER Blue Tide Manual De Instalación Y Mantenimiento

Unit placement

• The unit can be placed flat or upright and on top, inside or under the cabinet. Feed water connection should be as
close as possible to unit. However, if due to space or other limitations, this unit can be placed where it is convenient.
• When choosing a location for the unit, remember to have easy access to cold water line, drain pipe, power outlet, and
enough room to change filters.
All components and tubing should be located in an area not exposed to freezing temperatures or direct sunlight.
NOTE:

Feed Water Valve and Tee fitting

• Install Tee Fitting and Feed Water Valve as per diagram.
• Wrap threads of Feed Water Valve and Tee Fitting with Teflon Tape.
• Connect White Feed Water Tubing from unit to Feed Water Valve.
Install the Feed water valve.
Install the Feed water valve Tee fitting, and then connect
to source water.
Caution: The water supply to your unit MUST be from
COLD WATER LINE.
Use only a cold potable water supply as Feed Water, hot water will damage your unit. Softened Feed Water will
NOTE:
extend the life of the RO Membrane.

Drain Clamp Installation.

• Position drain clamp on drain pipe above the drain trap and tighten securely.
• Using the drain clamp as a guide, drill a 6mm hole, enough for the 1/4" tubing to pass through one side of the drain
pipe. DO NOT drill through both sides.
• Connect Red Waste Water Tubing from unit to drain clamp
When cutting the tubing make clean, square cuts, failing to do so result in poor connection and possible leaks.
NOTE:
The lowest point of the line should be the point of connection to the Drain Clamp. There should be no sag in the
CAUTION:
line as this may cause excessive noise as the reject water is flowing to drain
6
+1-503-GENPAR-6 - www.mygenpar.com
In the cabinet On the wall
Genpar Industries LLC USA
On the cabinet