Elta 2954 Manual Del Usuario página 9

2954 9/12/06 5:05 PM
PHONO
Note:
Remove the protective cap of the stylus. Before operating, make sure that the tone arm is unlocked
on the tone arm holder. Lock the tone arm once again after the playing process.
1. Press the ON/OFF SWITCH (5) to turn on.
2. Turn the FUNCTION SELECTION SWITCH (3) to Auto Stop ON or Auto Stop OFF.
3. Select the correct playing speed, which is dependent on the particular recording, with the speed
regulator.
4. Position the record on the record plate (use an adapter if necessary).
5. Lift the tone arm (9) off of the holder and lower it slowly onto the record. The record plate begins to
turn.
6. Bring the tone arm to the desired position.
7. Select the desired volume with the volume regulator (2).
8. The turning of the record plate will automatically stop when the record has finished playing, if the
function selection switch is in the Auto Stop ON position. Lift the tone arm (9) from the record and
set it back on its holder.
9. To stop the playing manually, lift the tone arm (9) from the record and set it on its holder.
10. Please set the function button (3) to Auto Stop OFF in order to be able to play discs with
overlength.
TROUBLESHOOTING
The ON/OFF BUTTON is on but the machine has no electricity.
• Check the electric current entry of the wall outlet.
• Check the power cable connection to the outlet.
The operation display is on, but there is no sound from the loudspeakers.
• Check the function selection switch.
• The Speaker/Aux switch must remain in the Speaker position.
• Check the set volume.
The radio has bad FM reception.
• Completely unwind the wire antenna for optimal reception.
CARE
ON/OF BUTTON
After use, turn the machine off by pressing the ON/OFF BUTTON.
Cleaning the machine.
To maintain the outer attractiveness of the machine, simply clean it with a soft, clean cloth soaked in
lukewarm water.
Safety advice:
• Do not connect the power cable to the outlet before all other connections have been made.
• Do not expose the machine to drips or sprays.
Replacing the stylus
The replacement of a used needle can simply be carried out as follows.
1. Lift up the tone arm.
2. To replace the old needle, pull the pick-up diagonally down. Keep the sheath of the crown secure
with your other hand.
3. Gently push the new needle into the holder (hold it firmly at the corner to avoid damaging the
needle) until it engages.
Page 09
09.