Cadet SBFT2 Instrucciones De Instalación

Benefits You Can Depend On
• Controls temperature with a 2-degree
comfort range for up to 28% savings on
your heating bill
• Save energy and time—customize up
to four daily programs, or use the 5-1-1
option to schedule your weekdays and
weekends
• Convenient push-button controls
• Digital display screen makes it easy to see
room temperature, time, and day
• Install on either end of standard Cadet
electric 240- or 208-volt baseboard
heaters
• 12.6 Amps for use with one heater only;
maximum 20 amp circuit
• Double pole (4 wires) with positive off
position
• Setpoint temperature range: 41º - 86ºF
• Your SBFT2 built-in thermostat is guaran-
teed with a 1 year limited warranty
TOOLS REQUIRED
• Phillips Screwdriver
• Insulated Wire Connectors
• Wire Strippers
• Wire Cutters
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the following:
1. Read all instructions before installing or using
this thermostat.
2. High temperatures may be generated under
certain abnormal conditions. Do not partially or
fully cover or obstruct the front of this heater.
3. Do not operate any heater after it malfunctions.
Disconnect power at service panel and have
heater inspected by a qualified electrician before
reusing.
4. To disconnect heater, turn controls to off, and
turn off power to heater circuit at main disconnect
panel.
cadetheat.com
IMPORTANT
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505
Smart-Base Built-In Thermostat Kit
Installation Instructions
http://www.cadetheat.com//electronic-thermostats/smart-base
The SBFT2 thermostat must be mounted in the same
wiring compartment as the supplied electrical power to
your Cadet Electric Baseboard. Both wiring compartments
are equipped with a grounding screw.
The installation of the SMART-BASE thermostat may
require a slight adjustment of the panel across the front
of the heater, to allow the thermostat to fit in the wiring
compartment unobstructed. To do so, remove both
wiring compartment covers and unlatch the bottom of the
front panel from its hangers. (Use a rubber-coated tool,
or hammer handle to remove the panel. Carefully pry
upward to remove.)
Next, slide the panel out of the wiring compartment with
the supplied electrical power, until its edge is just hanging
over the partition. Hold the panel and snap it back on to
its hangers. The thermostat will now have enough room
to fit into the wiring compartment.
5. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening as this may
cause an electric shock or fire, or damage the
heater.
6. To prevent a possible fire, do not block air
intakes or exhaust in any manner.
7. A heater has hot and arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or flammable vapors or liquids are used or
stored.
8. Do not use outdoors.
PO Box 1675 Vancouver, WA
Model SBFT2
98668-1675
Page 1