JAVAC JAV-1041 Instrucciones De Seguridad Y Manual De Funcionamiento página 3

DISPLAY
QUICK START
01. Install 2 'AAA' batteries.
02. Press and hold for 1 second.
03. Press and hold to change the vacuum measurement units.
04. Using the supplied coupler, connect the Micron Gauge to an unused service port, core removal tool, or
hose attached to the system.
05. Start the vacuum pump. Display will show vacuum pressure in selected units.
06. Press and hold for 1 second to turn the power off.
WARNING: To avoid damage, only hand tighten sensor connection. If greater torque is required, support the
sensor housing with a 3/4" wrench.
AUTO POWER-OFF
After 1 hour in Sleep Mode the Digital Vacuum Gaugewill automatically power off to further conserve
battery life.
BATTERY INSTALLATION
01. Remove battery cover from the back of the instrument.
02. Install 2 'AAA' Alkaline batteries observing polarity.
03. Replace battery cover.
BATTERY LEVEL INDICATOR
Four bars in the battery level indicator indicate full battery strength. As battery power is depleted, the
number of bars displayed decreases, until no bars are left. The Digital Vacuum Gaugewill turn itself off when
the batteries are fully consumed.
BACKLIGHT
Press and release to toggle the backlight on and off. To conserve battery power, the backlight will
automatically turn itself off after one minute.
HI-PRESSURE INDICATION
If the vacuum pressure exceeds 25,000 Microns (3330 Pa, 33.3 mBar, 25 mmHg/Torr), the display will show:
CAL: Indicates Calibration Self-Test and Field Calibration Mode
Torr: Torr Units Selected
Pa: Pascal Units Selected
mBar: Millibar Units Selected
Microns: Micron Units Selected
mmHg: mmHg Units Selected
Battery Level Indicator
3