KitchenIQ 50142 Manual Del Propietário página 10

will not re-start, contact customer service at (+1) 800-221-4156.
Symptom: Ceramic stones stop sharpening.
Cause: The ceramic stones will lose their sharpening ability over time, thus reducing
their effectiveness.
Solution: Ceramic stones are reversible and can be cleaned. Clean and reverse
stones as shown in Owner's Manual to restore original sharpening capabilities.
See "Reversing, Cleaning, and Replacement of Triangular Shaped Ceramic Stones"
section in this manual.
Symptom: The sharpener will not start when initially plugged into electrical socket.
Cause: Sharpener or electrical cord could be damaged or malfunctioning.
Solution: Contact customer service at (+1) 800-221-4156.
Reversing, Cleaning, and Replacement of Triangular Shaped Ceramic Stones
The module that holds the manual sharpening materials can easily be removed
from the top of the machine (Fig. 1) and opened so that the ceramic stones can be
reversed, cleaned, and/or replaced.
The brown ceramic darkens with use as the metal dust collects on the working
corners of the triangular stones, thus decreasing their sharpening capabilities.
The ceramic stones can be removed and rotated to expose an unused section of
ceramic or cleaned to refresh their abrasive quality. If rotating to use the other
side, spin each stone 180º then swap positions (Fig. 2). Use a small, nylon brush
to scrub the surface of the ceramic stones with kitchen cleansing powder and
water. After all possible working surfaces of the ceramic stones have been well
used and cleaning the stones does not increase their effectiveness, you should
replace the stones.
Reversing and Replacement of Carbide Sharpening Blades
The module that holds both of the manual sharpening materials can be easily
removed from the top of the machine and opened so that the carbides and the
ceramic stones can be reversed, replaced, and/or cleaned.
Carbides
The carbide cutting blades are reversible and replaceable. When the blades stop
cutting, they can be reversed and used on the other end or replaced.
Step 1. To reverse the blades, unscrew the module as shown in (Fig 1.)