On/Off Button; Horn Button; Light Button And Light Mode Led (For Optional Equipment); Hazard Button And Hazard Mode Led (For Optional Equipment) - Quantum R-net Instrucciones Básicas De Funcionamiento

10

On/Off Button

The on/off button turns the system on and off.
WARNING! Unless faced with an emergency
situation, do not use the on/off button to stop the
chair. This will cause the power chair to stop
abruptly.
WARNING! Always turn the power off when you
are stationary to prevent unexpected movement.

Horn Button

The horn button activates a warning horn.

Light Button and Light Mode LED (for Optional Equipment)

The light button controls the front headlights and rear running lights.
The light indicator will illuminate when the lights are activated. Press
once to turn on and press again to turn off.
Hazard Button and Hazard Mode LED (for Optional
Equipment)
The hazard button activates both turn indicators at the same time. You
can only cancel this by pressing the hazard button again. The hazard
LED will illuminate when the hazard button is activated.

Mode Button (Actuator Adjustment for Optional Equipment)

The mode button is used for optional equipment such as a power
elevating seat or power elevating leg rests. For specific operation of the
actuator buttons, refer to "Actuator Adjustment."

Profile Button

The profile button is used to change the drive profile. The R-net
Controller can be programmed with up to five (5) drive profiles. The
current profile is displayed on the LCD screen.
NOTE: The speed/profile increase and speed/profile decrease buttons are
used to change the drive profile on controllers equipped with an LED
keypad.
To change the drive profile:
1. Push the on/off button to power on the chair and the controller.
2. Press the profile button to select the next available profile.
3. Once the desired profile is displayed, the drive screen will be
displayed after a momentary pause.