Operating Modes; Mounting Diagram - Chauvet DJ TECHNO STROBE 2000S Manual Del Usario

Techno Strobe™ 2000S QRG EN
This product has a switchable power supply that can work with an input voltage
AC Power
of 120 VAC, 60 Hz or 230 VAC, 50 Hz.
The Techno Strobe™ 2000S has two modes of operation: Sound-Activated mode

Operating Modes

and Automatic mode. To switch between modes, use the Sound/Manual switch
located on the rear of the unit.
When operating in Sound-Activated mode, the sound sensitivity knob must be
adjusted to the proper sensitivity. In Automatic mode, the speed control knob will
adjust the flash rate of the strobe.
To avoid overheating, DO NOT operate this unit in fast strobing mode for
more than 20 minutes continuously.
Before mounting the Techno Strobe™ 2000S, read the Safety Notes in this QRG.
Mounting
Use at least one mounting point and one safety cable per product. Make sure the
mounting clamp is capable of supporting the weight of the product. For the
CHAUVET® line of mounting clamps, go to www.chauvetlighting.com/cables-
clamps-main.html.
Mounting Clamp
Safety Cable
(such as CLP-15 from Chauvet)
(such as CH-05 from Chauvet)

Mounting Diagram

4