User Instructions; How To Operate; Using Essential Oils - Welby 20099 Manual Del Usuario

User instructions

How to operate

CHECK DIFFUSER PLACEMENT – Place the diffuser on a non-metallic, lint free,
waterproof, level surface for best performance. This is to help disperse the mist in the
air and prevent it from being knocked or tipped over. Select a location for your
diffuser approximately 4 inches away from a wall. DO NOT place diffuser on a wood
finished floor or surface or near furniture which can be damaged by moisture or
water. Place on a water-resistant surface. Do not place diffuser on top of a towel, or a
carpeted surface. This may cause the diffuser to overheat.
1. Be sure the diffuser is unplugged from the electrical outlet.
2. Turn the mist cover of the diffuser slightly counter clockwise to remove it.
3. Remove the tank cover and fill with water without exceeding the maximum fill
line indicated. Measuring cup included.
4. Add 2-3 drops of essential oils (not included).
5. Replace the tank cover and then the mist cover. Diffuser will not put out any mist
unless both the tank and mist covers are in place.
6. Plug the diffuser in and choose from below options.
7. Maximum run-time on high is 5 hours.
Mist Button – This button controls the mist level.

Press one time for HIGH

Press two times for MEDIUM

Press three times for LOW

Press four times to turn to OFF
Light Button – This button controls the light

Press one time and the light will rotate in the following order:
Light blue – green – light blue – purple – red – light blue – blue

To choose one color only, press the light button a second time when it is on
the color of choice

Press a third time to turn the light OFF
PLEASE NOTE: When there is not enough water in the diffuser, the motor will stop
This indicates that the water level is insufficient or at zero. In this instance, unplug
the diffuser and refill the water tank.
User instructions
9