Use; Menu Information; User Installation; Antenna Setup - Zodiac DZR-3000FTA Manual De Empleo

USE

3. Menu Information

Once you have installed and connected the cables of the DZR, the menu will be displayed.
This menu consists of 5 menu options as shown below.
1.Channel Manager
2. Program Guide
3. Timer

4. User Installation

5. Receiver Information
6. Game
During the installation the OK key confirms a selection and LEFT/RIGHT key shows the Drop Down List box.
You can also use the numeric keys on the RCU to enter a numeric value.
Use hte PageUp and PageDown keys to move up or down from one line to another line. Use the VOL
LEFT/RIGHT keys to move from main menu to sub menu and move from left side to right side or vice versa.
To escape the menu system at anytime, press EXIT key on he RCU.
4. User Installation
This menu consists of 5 sub-menus as shown below.

1. Antenna Setup

2. Channel Search
3. System Setting
4. Parental Lock
5. Factory Default
4.1 Antenna Setup
1. Antenna: You can select a maximum of 16 antennas with the combination switches.
2. Type: Select your antenna type to be DiSEqC 1.2 or Fixde.
3. Satellite: Select first satellite you want.
4. LNB Type: Select your LNB type. If you have universal LNB, select Univ.
5. LNB Freq.: Enter the proper LNB frequency referring to your LNB using the numeric keys on the RCU or use
the KEY PAD displayed by pressing OK key.
If you have a dual LNB, enter the proper value in the value box.
6. Switches (0/12 Volt, 22KHz Tone, DiSEqC): You can select the switches with which you want to configure
the antenna.
7. C/Ku band control: You can select C/Ku band control by selectiing the switch type.
8. Channel Search: You can press ok to jump to Channel Search Menu.
4.1.1 East West Limit
On selecting Limit Setup button, the Limit Setup menu will pop up. Pressing the E key on the RCU continuously
will take you to the easternmost point. Press the OK key on the RCU: The message "Would you like to set East
limit of DiSEqC motor?" will be displayed for your confirmation. Place cursor on the OK button on the screen
and press OK key on the RCU to confirm the East limit.
4.1.2 Reset DiSEqC limit
If you want to reset the East limit or West limit, place the cursor on Reset DiSEqC Limit button and then press
OK key on the RCU. The message "Would you like to reset limit for DiSEqC positioner?" will be displayed for
your confirmation, Sselect OK button by pressing OK key on the RCU. The cursor will move to the East limit
button so that you can reset the limit. To reset West limits follow the same steps as East limits. Select EXIT to
finish antenna setup. The message "Are you sure to change the confiuration of Antenna setup?" will be
displayed. Select OK button on the screen and then wait for the data to be saved.
E - 4
ENGLISH