Using The Needle Threader; Threading The Lower Thread - Easy Home MS-201 Manual Del Usuario

− Use of the bobbin holder: Pull out the bobbin holder and remove the
spring. Insert one of the supplied bobbins and then put the spring back on
the bobbin holder. Firmly press the bobbin holder (including the spring)
back into the opening.
− Use of the spool pin: Extend the spool pin all the way out and place a spool
of thread on it.
3. Turn the handwheel
take-up
1
4. Insert the end of the thread through thread guide 1
5. Pull the thread from above down through the two discs of the tension
regulator for the upper thread
(see Fig. E).
6. Pull the thread through the thread guide in the thread take-up (from right
to left), then through thread guide 3
finally through the thread guide eyelet
needle.
7. Insert the end of the thread through the eye of the needle (left to right). You
can also use the needle threader
needle threader").
8. Lift the presser foot lever
in the gap of the presser foot
9. Pull approx. 4" (10 cm) of thread through the gap and place it behind the
sewing machine so that the end of the thread points away from you (see
Fig. B).

Using the needle threader

1. Guide the wire loop of the needle threader
needle from right to left.
2. Insert the thread through the wire loop.
3. Pull the wire loop and thread through the eye of the needle.
4. Remove the thread from the wire loop.

Threading the lower thread

• Only use the supplied bobbins!
• The upper thread must already be threaded when threading
1. Slide the case cover of the bobbin
2. Take the supplied bobbin
3. Place the bobbin in the bobbin case so that it rotates clockwise when
pulling on the thread.
7
clockwise until the needle
are both at the top.
26
the bobbin thread.
25
4 and guide it through thread guide 2
20
(from top to bottom), and then
(from top to bottom) above the
18
24
if necessary (see chapter "Using the
until it clicks into place. Then place the thread
14 .
24
15 to the left to remove it.
and wrap approx. 4" (10 cm) of thread around it.
and the thread
17
5 (from right to left).
through the eye of the
Start-up
2
17