Lightway SP-2016PIRB Manual Del Usuario página 7

_______
Install mounting bracket (A) onto junction box using the screws (C) or (D) (top
4.
and bottom of mounting bracket) while making sure the green ground wire
"GND" screw (L) is facing you (this will be found on the mounting bracket,
bottom center). Pull wires from junction box through the central opening.
NOTE:
a. If you are using a round junction box, use the short screw #10-24x5/8 (C)
and insert in the top and bottom opening
b. If you are using an octagonal junction box, use long the screw #8-32x25 (D)
and insert in the top and bottom holes
Loosen the green ground wire "GND" screw (L) on cover mounting bracket (A)
5.
and wrap the ground wire (copper wire) from the house junction box around
screw and tighten.
NOTE: If house wiring does not include a ground wire, consult your local
electrical code for approved grounding methods.
Next, locate cover mounting bracket gasket (B). Remove paper backing and
6.
adhere the gasket to the mounting bracket.
Use the wire nuts (E) to connect the black fixture wire to the black power
7.
supply wire and the white fixture wire to the white neutral supply wire.
Install security light fixture over mounting bracket (A) and gasket (B) by lining 8.
up holes and sliding openings on light fixture over the (2) M4X40 screws (F)
and screw on the decorative screw cap covers (G) to secure unit to the wall.
Apply silicone caulking (not included) around the perimeter of the back plate
9.
for moisture seal.
Adjust the lamps and sensor into direction desired.
10.
Turn on electricity at fuse and verify success of installation.
11.
___
SAVE THESE INSTRUCTIONS!
_______ Installation
7