LORCH ControlPro T Serie Manual De Instrucciones página 41

Control panel
LED Start current IS
39
lights up for selected parameters. The start cur-
rent can be changed with knob (34).
LED Start current time tS
40
lights up for selected parameters. The start cur-
rent time can be changed with knob (34).
LED Upslope
41
lights up for selected parameters. The upslope
can be changed with knob (34).
LED Electrode diameter
42
lights up for selected parameters. The electrode
diameter can be changed with knob (34).
LED Main current I1
43
lights up for selected parameters. The main cur-
rent is set with knob (34).
LED Second current I2
45
lights up for selected parameters. The second
current can be changed with knob (34).
LED Downslope
46
lights up for selected parameters.The downslope
can be changed with knob (34).
LED AC-Balance
47
1
lights up for selected parameter. The relationship
between positive and negative welding current
can be changed with knob (34).
LED Final current IE
48
lights up for selected parameters. The final cur-
rent can be changed with knob (34).
LED Final current time tE
49
lights up for selected parameters. The final cur-
rent time can be changed with knob (34).
LED Electrode diameter
50
lights up if an impermissible current is set for the
selected electrode diameter.
LED Gas post-flow time
51
lights up for selected parameters. The gas post-
flow time can be changed with knob (34).
LEDs Display units
52
indicate whether (35) voltage, seconds or millime-
tres are displayed on the 7-segment display.
LED Hold
lights up after completing a welding process. The
last adjusted welding current and welding voltage
is shown in the 7-segment display (36 and 35).
LEDs Display units
53
indicate whether (35) job no., percent values or
frequencies are displayed on the 7-segment dis-
play.
LED Seconds
54
lights up if seconds are displayed (36) on the
7-segment display.
LED Ampere
55
lights up if a current intensity is displayed (36) on
the 7-segment display.
LED VRD (only at machines with this option)
56
is permanently lit if the VRD-function is activated
04.19
(voltage reduction device)
blinks if the output voltage rises above the per-
mitted standard value (e.g. during the welding
process)
Tiptronic, gas test
LED Tiptronic
24
lights up if you select the tiptronic mode.
LED Tiptronic job active
57
lights up if an active job is selected.
The save switch
58
saves tiptronic jobs
The gas test switch
59
sets the shielding gas quantity and checks the
gas supply.
909.1709.9-05 - 41 -