Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use only mild soap and damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING
:
the charger from the AC outlet before
cleaning.
Dirt and grease may be removed from the
exterior of the charger using a cloth or soft
non-metallic brush. Do not use water or
any cleaning solutions.
REPLACEMENT PARTS
Use only identical replacement parts. For a
parts list or to order parts, visit our service
website at www.portercable.com. You can also
order parts from your nearest PORTER-CABLE
Factory Service Center or PORTER-CABLE
Authorized Warranty Service Center. Or, you
can call our Customer Care Center at
(888) 848-5175.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
Shock hazard. Disconnect
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.
SERVICE AND REPAIRS
All quality tools will eventually require servicing
and/or replacement of parts. For information about
PORTER-CABLE, its factory service centers or
authorized warranty service centers, visit our website
at www.portercable.com or call our Customer Care
Center at (888) 848-5175. All repairs made by our
service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee
repairs made or attempted by others. You can also
write to us for information at PORTER-CABLE, 4825
Highway 45 North, Jackson, Tennessee 38305, (888)
848-5175 - Attention: Product Service. Be sure to
include all of the information shown on the nameplate
of your tool (model number, type, serial number, etc.).
ACCESSORIES
WARNING
than those offered by PORTER-CABLE,
have not been tested with this product,
use of such accessories with this tool
could be hazardous. To reduce the risk of
injury, only PORTER-CABLE
recommended accessories should be
used with this product.
A complete line of accessories is
available from your PORTER-CABLE
Factory Service Center or a PORTER-
CABLE Authorized Warranty Service
Center. Please visit our Web Site www.
portercable.com for a catalog or for the
name of your nearest supplier.
11
:
Since accessories, other
Tabla de contenido
