On/Off Switch; Rechargeable Battery - Fellowes Penguin Manual Del Usuario

WIRED VERSION
1. Plug the USB cable into any spare USB port.
WIRELESS VERSION
2.4 GHz USB Micro Receiver
The micro receiver is located inside the housing on the underneath of the
Penguin (J).
1. Remove the micro receiver and insert into a spare USB port of your
computer or laptop. Wait for a short time for your PC to recognize the
penguin mouse.
2. Make sure the ON/OFF switch (F) on the base is in the 'ON' position.

On/off switch

For normal working conditions, make sure the ON/OFF switch (F) is turned to
the 'ON' position. The ON/OFF switch is located on the base of the Penguin.
Note: It is advised to switch to the 'OFF' position if the Penguin is to be
transported as this will conserve power.
Auto power save
After approximately 20 seconds inactive - Penguin enters power save mode
After approximately 5 minutes - Penguin enters deep sleep mode
Inactive - click any button to reawaken

Rechargeable battery

The Wireless Penguin has an internal rechargeable battery. There may be a
certain amount of charge already in the battery.
To fully charge the battery, insert the USB end of the cable (G) into a spare
USB port of your computer and the DC end of the cable into the front of
your mouse (I) see diagram. Refer to the Charging Light Sequence section to
indicate the battery level.