Flymo IT20BBA Manual De Usario página 6

CHARGING THE BATTERY PACK
a WARNING: Do not use the charger in direct sunlight. Recharge at
temperatures between 0°C and 40°C (32°F and 104°F).
a WARNING: If the battery pack is hot, allow it to cool down before
recharging.
1. Plug the charger into an AC power outlet.
2. Slide the charger over the battery pack terminals. Make sure the charger and
battery pack are fully connected.
• When the battery pack is charging, the LED will blink.
• When the battery pack is fully charged, the LED will stop blinking but will remain
illuminated.
• Once all charging lights turn green, remove the battery pack from the charger
and disconnect the charger from the outlet.
• Store the battery pack fully charged.
• Make sure the battery pack and battery pack charger are clean and that the
terminals on the battery pack and the battery pack charger are always clean and
dry before the battery pack is placed in the battery pack charger.
• Keep the battery pack guide tracks clean. Clean plastic parts with a clean and
dry cloth.
• Symbols on the product or the package show that this product cannot be made
domestic waste. It must be sent to an applicable recycling location for the
recovery of electrical and electronic equipment.
• Make sure to discard the product safely and correctly. This helps prevent a
possible negative effect on the environment and other persons. For more
information about recycling this product, speak to your municipality, your
domestic waste center or the shop from where you purchased the product.
6
MAINTENANCE
DISPOSAL