Technical Characteristics - NOVASTAT RF WEEK Manual De Usuario

USER GUIDE - NOVASTAT RF WEEK (RT-RFWP)
USER GUIDE
F
EATURES

7 days program
( except for daily version)

9 Built-in programs

4 User programs

Program graphic display

Room temperature and Time display

Comfort / Reduced / Anti-freeze
temperatures

Temporary temperature override

Automatic or Manual operation

Holiday function
T
ECHNICAL CHARACTERISTICS
Measured temperature
0.1°C (or 0.2°F)
precision
Set temperature precision 0.5°C (or 0.5°F)
in comfort & reduced : 5°C - 35°C (or 41°F - 95°F)
Set temperature range
in anti-freeze : 0,5°C - 10°C (or 33°F -50°F)
Proportional band regulation
Regulation
Cycle: 15 minutes or
characteristics
Anti-short cycle: 3min in OFF, 2min in ON.
Radio frequency
868 MHz, <10mW.
CE. EN 300220-1, EN 301489-1
Certifications
Radio frequency certifications
Electrical Protection
Class II - IP30
3x LR6 AA 1.5V Alkaline batteries
Batteries
IMPORTANT: You have 1 minute to change the batteries
Software version Displayed when the thermostat is turned Off
The RT-RFWP Chrono-thermostat is a
programmable digital thermostat able to
control and regulate directly your central
heating (Electric, Gas, Oil) or cooling
system. It's weekly programmable function
enables power savings according to your
every day life.

Select HOT or COLD operation

Suitable for NC and NO actuators

Keypad lock function (child safety)

Battery powered to prevent loss of
program
and time during power cuts

Battery weakness monitoring

Battery replacement without loss of
program

Reset function
RADIO CONFIGURATION WITH THE RECEIVER
1. On the RT-RFWP, select operating mode.
Then press the OK key during 5 seconds,
you will enter in the Radio configuration mode (
The RT-RFWP is now sending by radio signal its configuration address 4 times per second,
2. On the receiver, press on the push button during 4 seconds,
the Green LED should lit up and then starts to blink at each radio signal received from the
RT-RFWP (4 blinks per second).
3. You can now perform a radio range verification.
Place the RT-RFWP in the room where you need to regulate the temperature and leave it in
"Radio configuration" mode (
Close the doors and come back to the receiver.
Verify that the green LED blinks at each radio signal received :
- If it blinks regularly 4 times per second, the installation of the RT-RFWP and receiver is
correct.
- If it blinks irregularly, you are at the range limit. Install the RT-RFWP closer to the receiver.
- If it does not blink at all, you are out of range. Install the RT-RFWP closer to the receiver.
4. On the RT-RFWP press on the OK key to exit the Radio configuration mode.
Now your RT-RFWP controls the room temperature by the receiver.
Additional information:
If the week program at RT-RFWP is adjusted, a free program without settings must be
selected with the MASTER/TIMER-RF.
INSTRUCTIONS
Holiday function activated
Temperature overridden
Central heating working
Temperature
use + / - keys
to change temperature
Room temperature displayed
).
).
Operating mode MENU
Graphic program display
Instruction RF Week GB_PPLIMW15037Ab
GB
use   keys
to change mode
Weak Batteries
Week days
Time display