Installing The Device; Wall Mounting Installation - Duux Slim 1000 Manual De Usuario

• This heater is hot when in use. To avoid burns
and personal injury, do not touch hot surfaces.
Make sure that no other appliances are plugged
•
in the same electrical outlet as this may cause
overload.
Children under 3 years should be kept away
•
unless continuously supervised. Children aged
from 3 years and less than 8 years shall only
switch on/off the appliance provided that it has
been placed or installed in its intended normal
operating position and they have been given
supervision or instruction concerning use of
the appliance in a safe way and understand the
hazards involved. Children aged from 3 years and
less than 8 years should not plug in, regulate and
clean the appliance or perform maintenance.
Caution: Some parts of this product can become
very hot and cause burns. Particular attention to
children and vulnerable persons is required.
This appliance can be used by persons with
•
reduced physical, sensory or mental capabilities
or children aged from 8 years and above if they
have been given supervision or instruction
concerning use of the appliance in a safe way and
understand the hazards involved. Children shall
not play with the appliance.
6

Installing the device

This heater can be used with the aluminum
floorstand or wall mounted, If you use the product
on a flat surface, it must be attached to the
aluminum floorstand before operating the unit.
Both assembly instructions can be found below.
Note: This unit is for floor use or wall mounting
use only.
Warning: Do not operate the device without the
aluminum floorstand or wall bracket. Operate the
heater only in upright position. Any other position
or angle could create a hazardous situation.
Warning: Do not install this product vertically,
or it will stop work or cause risk of fire. Install
product as figure A, B, C, D, E.
Aluminum floorstand installation
Unpack both aluminum feet and take out the
1
rubber plug (see figure A)
Put the product on a suitable and stable
2
position and use an allen key to attach the
feet with screws (see figure B)
After the aluminum floorstand has been
3
installed, put the product in an upright
position on the floor (see figure C). Now the
product can be operated.
Note: Pay attention to the correct position of the
feet. The short side of the feet should be on the front
side of the product.
A
B
C

Wall mounting installation

Drill 4 holes with a diameter of 8mm at the
1
positions in figure A and add wall plugs into 4
holes.
Fix the horizontal bracket on the wall with
2
screws (see figure B).
Install the vertical bracket with screws onto the
3
horizontal bracket (see figure C)
Once installed the bracket, add the rubber
4
case onto the end of the vertical bracket
to protect the bracket from scratching the
product (see figure D)
After finishing the installation of the bracket,
5
align the holes on back of product and click
the horizontal bracket into the product. Once
attached, move leftwards to fix the product
(see figure E)
Note: To remove the heater from the bracket,
please operate by moving to opposite directions
from installation.
A
B
C D
E
Placement & connecting
Before using the heater, make sure that it is on
a flat and stable surface. The heater must be
connected to an appropriate electrical outlet. Keep
loose clothing or bedding, furniture and flammable
material away from the wall outlet where the
heater is plugged in.
7