Additional Precautions - Drive 11132-1 Manual Del Usuario

commode assembly
instructions and precautions
Figure 1
WEIGHT CAPACITY: 1000 LBS.
assembling commode seat & lid:
1. Before assembling, allow toilet seat and lid to reach
room temperature if exposed to cold. This will help
prevent the seat and lid clamps from cracking while
being assembled onto commode back frame rail.
2. Align the toilet seat clamps onto the back frame
rail. (Both clamps should sit outside the pail
brackets.) Push down on seat until clamps snap
firmly into place.
3. Slide pail in from front of commode.
Seat Clamps

additional precautions

1. Toilet seat must be in down position before use.
Failure to do so may result in breakage of commode
and possible injury.
2. Do NOT install commode without first reading and
understanding this assembly and instruction sheet.
If you can not understand these instructions, contact
a healthcare, dealer or technical professional
before attempting to install. Otherwise, injury or
damage may occur.
3. Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO NOT
USE. Contact dealer/carrier for further instructions.
4. Ensure ALL screws, nuts and/or bolts are tightened.
5. Check the rubber tips on the leg extensions for rips,
wear or if they are are missing. Immediately replace
any or all if any of these imperfections exist.
6. All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.
7. Users with limited physical strength should be
supervised or assisted while using commode.
EXAMINE THE FOLLOWING ANNUALLY
• Make sure the leg support buttons are securely
through their height adjustment holes
• Examine the unit for loose, missing, or damaged
nuts, bolts, screws, knobs. Tighten or replace as
necessary.