How To Use The Chopping Attachment - Sencor SHB 436 NAA1 Serie Manual De Instrucciones

SHB 436XXX-NAA1/SHB 4360-NAA1/ SHB 4361BL-NAA1/SHB 4362GR-NAA1/SHB 4363OR-NAA1/ SHB 4364RD-NAA1/
SHB 4365VT-NAA1/SHB 4366YL-NAA1/SHB 4367TQ-NAA1/SHB 4368RS-NAA1

HOW TO USE THE CHOPPING ATTACHMENT

The chopping attachment is suitable for chopping food, such as meat, hard cheese (e.g. Parmesan), veg-
etable (e.g. onion, garlic, carrots etc.), herbs, nuts (e.g. hazelnuts, walnuts etc.), dried fruit (e.g. prunes) and
other type of food.
The chopping attachment has not been designed to cut ice cubes, spices (e.g. nutmug), coffee beans or
similar type of food.
Before inserting food into the bowl it is necessary to cut the food into small pieces.
Chopping attachment assembly:
1)
2)
3)
4)
5)
6)
Note: Use the device for no longer than 1 minute.
Note: When assembling/disassembling the chopping attachment always make
Note: To disassemble,
Copyright © 2014, Fast ČR, a.s. Copyright © 2016, Fast ČR, a.s.
Stick Blender
Place a rubber non-slip
The rubber prevent the attachment from accidental s ipping and
tipping over and possible
Carefully insert a cutting knife (A10) into the chopper bowl (A11). Set the
cutting knife onto the central spindle of the bowl. Always hold the cutting
knife by the plastic part.
Caution: The cutting knife is very sharp!
Put the food you wish to chop into the bowl. The amount should not exceed
Put the food you wish to chop into the bowl. The amount should not
the maximum limit (16.9 fl .oz / 2.1 cups / 500 ml) that is marked on the bowl.
exceed the maximum limit (500 ml) that is marked on the bowl.
Place a lid (A9) on the bowl. The bowl should be put so that the pressing
center, located on the underside of the lid, is placed on the cross of
the cutting knife as well as the security locks, located on the sides of the lid,
fit into the bowl system. Once the lid is placed correctly, turn the
lid clock wise
click.
To release the lid, turn
release is also indicated by a click. When releasing the lid pay higher
attention so that it will not tip over or release of cutting knife and
possible .
Place the motor unit (A3) onto the assembled chopping attachment.
Now the device is ready to use. Insert the plug into the power outlet. After
inserting into the power outlet the switch (A2) will be highlighted.
sure the device is switched off and power cord is removed from the
power outlet.
EN-7
(A12) onto the bottom of a chopper bowl.
.
The safe locking is indicated by a
the lid . The lid
05/2016 10/2014