Connect The Cables And Power Cord - Digital 1200 Serie Guia De Instalacion

4

Connect the cables and power cord

1. Connect the mouse and keyboard cables into the
corresponding connectors at the back of the server.
2. Place your monitor near your server. Connect the
monitor signal cable to the back of the monitor and
then connect it to the matching connector at the back
of your server. Note that some monitors have cables
permanently attached.
3. Connect the monitor power cord to the back of the
monitor, then to a wall outlet.
4. Connect the server power cord to the server, then to a
wall outlet.
6
CAUTION
The voltage selection switch must match the
voltage supplied by your power outlet. In North
America, 115 volts is common. In other countries,
230 volts is common. Ensure that the voltage
selection switch is set to the right voltage. If it is
not set correctly, you can damage your server.
Do not attempt to modify or use an external
100 Vac (Japan only) or 115 Vac power cord for
240 Vac input power. Modifying either cord can
cause severe equipment damage.
DIGITAL Server 1200 Series