Battery Replacement - Rohde & Schwarz Hameg HZ56-2 Manual

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Battery Replacement

Warning
To avoid personal injury, always ensure the probe
is removed from any live electric circuit, and leads
are disconnected before removing the battery co-
ver. Never operate the probe without the battery
cover fi tted.
The red LED will fl ash when the minimum operating voltage
is approached. Refer to Fig.1. Use the following procedure:
1. Unclamp the probe from the conductor, turn it off using
the On – Off switch and disconnect the output leads, from
external equipment.
2. Loosen the captive screw that secures the battery cover.
Lift the cover through 30° and pull it clear of the probe
body as shown in Fig 1. The battery is then accessible.
Replace the battery and re-fi t the battery cover and fasten
the screw.
Note:
Replacement with other than the specifi ed type of
battery will invalidate the warranty.
Fit only the type 9 V PP3 Alkaline (MN 1604).
STOP
18
Subject to change without notice
Tabla de contenido
loading

Tabla de contenido