Honeywell Home CT230-GA Guia De Instalacion página 6

Installation Guide
Installing the CT230 linked units
Install each CT230 linked unit as follows:

Turn the heating system off at the main electrical panel.

Loosen the bottom screw and remove the CT230 faceplate
from the wallplate. (The screw cannot be completely
removed.)

Connect the wallplate to the load (heating cables) and to the
power supply (see wiring diagram on page 6).
NOTE: The CT230 linked units can operate on different
voltages in the same setup (e.g., 5 units @ 120 V and
5 @ 240 V).

Install the wallplate to the electrical box using the provided
screws.
4
Faceplate
Wall-