Assembly - Parkside PWS A1 Instrucciones De Utilización Y De Seguridad

Check before and regularly during use that
the screws, bolts and other fixings are firmly
seated.
Check the product regularly for damage. Vi-
brations can loosen screws, bolts and other
fixings during use.
Never use your product if you discover that
it is damaged in any way.
Ensure that the cutting disc of your angle
grinder is mounted at right angles to the
base plate.
Use cutting discs only and not roughing
discs in this product.
Check the cutting disc of your angle grinder
regularly for damage.
Never use a disc if you discover it has any
dents, nicks or other damage. It could disin-
tegrate.
Do not allow parts of your body to come
within working range of the cutting disc until
after it has come to a standstill.
When cutting follow the instructions of the
manufacturers of the electrical power tool
and the cutting disc.
Use angle grinders that have a cutting disc
diameter of 115 or 125 mm only.
Do not allow anyone else to
come within the working range of
the product while you are using it.
Grip the handle tightly when using the angle
grinder and position your body and arm to
allow you to resist kickback forces.
Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an exces-
sive depth of cut. Overstressing the wheel
increases the loading and susceptibility to
twisting or binding of the wheel in the cut
and the possibility of kickback or wheel
breakage.
When the wheel is binding or when inter-
rupting a cut for any reason, switch off the
power tool and hold the cutting unit motion-
less until the wheel comes to a complete stop.
Never attempt to remove the wheel from the
cut while the wheel is in motion otherwise
kickback may occur. Investigate and take
34 GB/MT
corrective action to eliminate the cause of
wheel binding.
Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed
and carefully re-enter the cut. The wheel may
bind, walk up or kickback if the power tool
is restarted in the workpiece.

Assembly

CAUTION! DANGER OF FIRE! Assem-
ble and use the product on a fire-resistant sur-
face only.
Follow these steps:
Fasten the saddle
with the hexagonal socket head screws
20
and washers
23 22
Fig. 1).
Fasten the handle
with the projecting screw thread and the
corresponding nut (see Fig. 2).
Now push the plastic locating pieces
the mounting pieces
of the mount (see Fig. 3).
24
Then attach the mounting pieces
through the plastic locating pieces
the hexagonal socket head screws
elongated holes in the mount
Insert the adjustment screw
bottom hole and the adjustment screw
through the top hole of the mount
Fig. 4). Note that later the rubber buffers of
these screws must lie against the angle grinder
housing.
Note: First insert these screws so that the
rubber buffers lie directly against the mount
Note: Please bear in mind that the angle
grinder must be fitted with a suitable cutting
disc before assembly. It is not possible to
change the disc with the angle grinder in-
stalled in the product.
Now prepare for mounting the angle grinder
in the mount .
24
on to the base plate
21
by Allen key (see
28
on to the mount
3 24
12
, on to the guide
11 26
,
11 26
with
12
in the 19
(see Fig. 3).
24
through the
13
1
(see
24
of
.
24