Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Wall S leeve Brands:
4
4
8
8
3
3
#7 Whirlpool
1. Remove existing rear grille as shown on Page
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE:
You may need to drill holes in flange of
existing sleeve to match new rear grille.
Because of the increased unit depth, first try
dry fitting using the method described below:
2. Place (2) 1
x1
3. Gently slide unit in and check if amount extend-
ing from the sleeve is sufficient once the trim
frame is attached.
4. If position is Ok , remove unit and proceed to
the next s tep. If not go to step 9.
5. Attach (1)1
at the top of the sleev e. Remove the bac king
paper and pres s into position.
6. Attach (2) 1
right sides of the sleeve.
7. Cut (2) 1
x
3
/
8
and attac h to
the vertical sections of the grille as
shown
.
8. Attach the tapered spacer blocks to the floor of
the sleeve. Now go to step 15.
Use these next steps if the unit requires extra
extension into the room.
9. Attach 1 x
3
x14 long seal over the solid
/
4
vertical portion of the rear grille.
3
/
10. A ttach (2) 4
4
slot overlapping the seal above.
11. Install the divider into the s lots of the foam
blocks. You may need to trim the length to size.
12. Repeat steps 9-11 for the other v ertical shown
portion of the grille as shown in the pic ture.
13. A ttach (2) 1
of the sleeve again m aking sure all seals are
flush.
14.
Cut the 1
x1
sleeve. The pieces m ust be fitted flush to the
edge of the div ider.
15. Center unit and gently slide unit into sleeve.
16. Before sliding all-the-way back, remove 1st
sc rew from front on left side of unit.
17. Remove the plastic washer from the sc rew.
18. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
19.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
not become tangled.
20.Seal & Frame the unit as described on page 17.
21
. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
mounting on Page 16.
13
( 23 Deep)
1
/
x14 seals against eac h side.
2
1
/
x1
x25 long seal in the c enter
2
1
x1
/
x14 seals to the left and
2
x25 long seals to 14 long
3
3
/
x3
/
x1 foam blocks with the
4
4
x1
x14 seals along the sides
1
/
2
1
x25 seal to fit the top of the
/
2
Tabla de contenido
