Basic Commands (Direct Access)
No confirmation LED's on.
Arm
Press and release
The alarm arms, doors lock, and the siren chirps and parking lights
flash. The Arm LED and beeps play to confirm. If Valet mode* is On,
the doors lock and the Arm LED and a fault tone plays. Exit Valet mode
to arm the alarm normally.
If a trigger zone fault is detected the siren chirps once again and the
remote will emit a Trigger Zone Fault Report**, the Arm LED and a
fault tone plays.
To Arm and Panic
Press and hold
The alarm Arms (or Locks in Valet) and, after two seconds, sounds
the siren and flashes the parking lights. The confirmation LED's
flash and siren tones play to confirm. Press the
to stop the output.
Disarm
Press and release
The alarm disarms, doors unlock, and the siren chirps and parking
lights flash. The Disarm LED and beeps play to confirm. If Valet mode*
is On, the doors unlock and the Disarm LED and fault tones play.
An Alarm Report** will replace the disarm output if the alarm was
triggered; the siren will chirp four or five times, and the Disarm LED
© 2014 Directed. All rights reserved.
AUX
AUX
AUX
AUX
AUX
AUX
or
button
AUX
AUX
AUX
AUX
5