Idiomas disponibles
Idiomas disponibles
3 41 01 118 06 0.book Seite 16 Mittwoch, 5. März 2014 10:27 10
en
16
Character
Unit of measure,
international
n
/min
V
P
W
1
P
W
2
f
Hz
M...
mm
Ø
mm
mm
mm
M
l
L
dB
wA
L
dB
pA
L
dB
pCpeak
K...
2
m/s
2
m/s
h,P
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
For your safety.
Read all safety warnings and all instruc-
WARNING
tions. Failure to follow the warnings
and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
hand-guided polisher for polishing in weather-protected
environments using the application tools and accessories
recommended by FEIN.
This machine is also intended to be powered by a.c. gen-
erators with sufficient power output that correspond
with ISO 8528, design class G2. Compliance with this
Standard in particular is not given when the so-called dis-
tortion factor exceeds 10%. When in doubt, inform
yourself about the generator in use.
Unit of measure,
national
rpm
V
W
W
Hz
mm
mm
mm
mm
dB
dB
dB
2
m/s
2
m/s
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
2
min, m/s
Safety warnings common for polishing
This power tool is to be used as a polisher. Observe all
safety warnings, instructions, illustrations and data sup-
plied with the power tool. Non-observance of the follow-
ing instructions can lead to electric shock, fire and/or
serious injury.
This power tool is not suitable for grinding, working with
wire brushes, sanding with sanding discs and cut-off grind-
ing. Operations for which the power tool was not
designed may create a hazard and cause personal injury.
Do not use accessories which are not specifically designed
and recommended by the tool manufacturer. Just because
the accessory can be attached to your power tool, it does
not assure safe operation.
The rated speed of the accessory must be at least equal to
the maximum speed marked on the power tool. Accessories
running faster than their rated speed can break and fly
apart.
The outside diameter and the thickness of your accessory
must be within the capacity rating of your power tool.
Incorrectly sized accessories cannot be adequately
guarded or controlled.
Threaded mounting of accessories must match the grinder
spindle thread. For accessories mounted by flanges, the
arbour hole of the accessory must fit the locating diameter
of the flange. Accessories that do not match the mounting
hardware of the power tool will run out of balance,
vibrate excessively and may cause loss of control.
Explanation
Rated speed
Rated voltage
Power input
Output
Frequency
Size of metric thread
Diameter of a round part
Ø
=Max. application tool diameter
D
M=Thread for clamping flange
l=Length of mounting thread
Sound power level
Sound pressure level
Peak sound pressure level
Uncertainty
Vibration emission value (triax vector sum) deter-
mined according to EN 60745
Mean vibrational value for polishing
Basic and derived units of measure from the inter-
national system of units SI.
