Care And Maintenance; Problem Solving - Graco Silhouette Instrucciones

CARE AND MAINTENANCE

FROM TIME TO TIME CHECK YOUR SWING for
loose screws, worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only
Graco replacement parts.
REMOVABLE CLOTH SEAT COVER may be
machine washed in cold water on delicate cycle and
drip-dried. NO BLEACH.
TO CLEAN FRAME, use only household soap
and warm water.
NO BLEACH or detergent.
Excessive exposure to sun or heat could cause fading
or warping of parts.

PROBLEM SOLVING

Swing won't operate:
1. No batteries in swing.
2. Batteries dead.
3. Speed setting too low.
4. Batteries in backwards — check "+" and "-".
5. Corrosion on battery terminals. Rotate bateries in
place against
terminals, or clean with sandpaper or steel wool if
corrosion is severe.
6. Baby leaning too far forward.
7. Baby grabbing swing legs. (Discontinue use.)
8. Seat not pushed high enough for a good start.
9. Protective device activated. (Turn off motor, wait 3
minutes, then restart swing.)
Seat doesn't swing very high:
1. Control setting too low.
2. Blanket hanging down, causing increased
wind resistance.
3. Batteries too weak.
4. Baby leaning too far forward.
5. Baby too heavy or too active. (Discontinue use.)
6. Soft carpet (swings higher on hard floors).
10