Idiomas disponibles
Idiomas disponibles
3
Connect your Ethernet cable to the Ethernet port on the rear of the
loader. The Ethernet connection allows use of the Web Client.
4
Connect a power cord to the power connector on the rear of the
loader. US and EU power cords are supplied with the loader.
5
Power on the loader by turning on the rear power switch.
6
Power up the host system.
7
Verify that the host can communicate with the loader's tape drive.
8
Configure your loader using the loader's operator panel.
Table: Power Requirements
Power Requirements
Input Voltage
Input Current
Input Frequency
2
Values
100 – 240 VAC
0.6 – 0.3 A
50 – 60 Hz
Quick Installation Guide
