General Specifications; Important Safety Instructions - Paul Mitchell protools GI10NAB20 Guía De Garantía, Seguridad E Instrucciones

Ocultar thumbs

Contenido

página de 15

/ 15
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

SPRING REPLACEMENT INSTRUCTIONS

Turn off the iron and unplug it, ensuring it has cooled

completely before replacing the spring.

1. Remove the screws from the barrel: Hold the iron by the

barrel and push down gently on the thumb grip. Use a small

Phillips screwdriver to remove one screw, then the other.

Barrel

2. Remove the old spring from the barrel: Using a small Phillips

screwdriver, gently loosen the screw—a quarter or half turn

counterclockwise should remove the screw. Pinch the spring's

coils together and pull the spring out of the bracket.

3. Insert the new spring: Pinch the new spring's coils together

and insert it into the bracket. Do not push the spring in as far

as it will go, but leave a small portion of the rods extending

from the bracket.

4. Tighten the bracket screw carefully, keeping the new

spring straight on the barrel.

5. Replace the clamp: Holding the iron by the barrel, align the

clamp's screw holes with the screw holes in the barrel. Insert

each screw.

6. Test the clamp several times to ensure the iron works

properly.

Rated Wattage

Rated Voltage(V)

Frequency(Hz)

Weight (g)

Length of A.C. Cord

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING.

DANGER – Any appliance is electrically live, even when the

switch is off. When not in use, always unplug the iron to prevent

the risk of fire.

WARNING – To reduce the risk of burns, electrocution, fire, or

injury to persons and/or personal property:

• Use the iron only for the purpose described in this guide to

prevent accidents, damage or malfunction.

• This appliance should never be left unattended when

plugged in.

• Avoid multiple cables to a plug or use of an extension cord

to prevent starting a fire from overheating.

• KEEP AWAY FROM WATER to prevent fire, electric shock,

damage or malfunction.

• KEEP AWAY FROM CHILDREN.

• Do not handle the iron or cord with wet hands as this may

cause electric shock.

• Do not leave the iron in a position where it can fall or be

pulled into a tub or sink.

• Keep the cord away from heated surfaces.

• DO NOT WRAP THE CORD AROUND THE IRON.

Clamp

Screw