Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
2-2
Align the rear segments of the bracket set with the cage
nuts.
2-3
Insert and tighten four Phillips pan-head screws (provided
with your rack enclosure).
3
Attach Front Rail Segments to the Automatic Transfer Switch
3-1
Align the front rail segments of the bracket set with the
corresponding holes located on the sides of the Automatic
Transfer Switch (ATS).
3-2
Attach both front segments to each side of the ATS using six
Phillips flat-head screws (included).
4
Install the Automatic Transfer Switch in the Rack Enclosure
Note: Two people should perform this procedure.
4-1
Position the ATS in front of the mounted rear rail bracket
segments.
2-2
2-3
3-1
3-2
4-1
3
Tabla de contenido
