SHELF-MADE 240-BK Instrucciones De Instalación

Installation Instructions
Shadow Boxes
240-BK | 240-WT
Tools Required (not included):
- Power Drill
- 3/32" Drill Bit or 3/16" Drill Bit
- Screwdriver
- Tape Measure
- Level
Installation Materials (included):
- (3) Shadow Boxes
- Mounting Hardware
Load Rating:
- 50 lbs each cube when mounted
onto studs
2700 Oak Industrial Dr. NE
Grand Rapids, MI 49505
800-253-1561
www.kv.com
[email protected]
Installation
:
STEP 1: Select installation areas and mark keyhole locations on wall the correct distance
apart. Use a level to make sure shadow boxes will be straight as shown in Figure 1.
STEP 2: Pre-drill pilot holes with a 3/32" drill bit in the marked locations. If a stud is
present, insert and fasten the screw leaving a 3/16" gap. If no stud is present, use a
3/16" drill bit to bore out the 3/32" hole, then insert the anchor and fasten the screw
into the anchor leaving a 3/16" gap as shown in Figure 2.
STEP 3: Attach each shadow boxes by placing the keyholes over the screws and applying a
light downward force as shown in Figure 3.
x
x
Level
Back of
Decorative Cube
Figure 1
Figure 3
©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt.
3/16"
Stud
Figure 2
3/16"
310459/0715