Aux Mode; Tuner Mode - ION Complete LP Guia De Inicio Rapido

Playing your records:
1. Press the Mode button until PHONO is seen on the display.
2. Set the Speed Control switch to the desired speed (33 1/3, 45, 78 rpm).
3. Place the record on the platter and adjust the tonearm on the record to begin playback.
4. Adjust the Volume knob on Complete LP.
Note: Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order to hear the station.

Aux Mode

1. Connect your device to the Line In using a stereo 1/8" (3.5mm) cable.
2. Press the Mode button until BT AUX is seen on the display.
3. Adjust the volume from your output device.
CD Mode
1. Press the Open/Close button to insert a MP3, CD-R, or CD-RW into the CD tray.
2. Press the Mode button until CD is seen in the display.
3. Press PREV/NEXT to select a different track.
4. Press PLAY/PAUSE to play or pause a track.
Note: Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order to hear the station.
USB Mode
1. Connect a USB flash drive to the unit.
2. Press the CD/USB button until USB is seen on the display. It will automatically start playback of the songs on
the USB flash drive.
3. Press PREV/NEXT to select a different track.
4. Press PLAY/PAUSE to play or pause a track.
Note: Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order to hear the station.

Tuner Mode

1. Press AM/FM to toggle between the AM and FM bands.
2. Adjust the TUNE knob to select the channel you want.
3. Hold either the PREV or NEXT button to go to the strongest radio station signal.
Note: Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order to hear the station.
To save a radio station as a preset:
1. Press the OPEN/CLOSE button.
2. Change the preset slot by pressing the PREV or NEXT button while the preset slot number is still flashing.
3. Press OPEN/CLOSE to confirm your save.
4. Toggle between saved presets using the PREV or NEXT button when in Tuner mode.
Troubleshooting
I am playing a record but do not hearing any audio:
• If you are playing music from vinyl:
o Make sure that Complete LP is powered on and that the needle is on the record.
o If headphones are connected to Complete LP, disconnect the headphones in order to hear sound from
the internal speakers.
My record is not playing at the correct speed; its pitch is too high or too low:
o Ensure the 33 / 45 / 78 switch is set to the correct speed for your record.
I am connected to a Bluetooth speaker but do not hear any audio.
o Turn Complete LP off and then on again, and then try pairing it again.
o Use the volume knob on Complete LP to turn up the Bluetooth output level.
o If headphones are connected to Complete LP, disconnect the headphones in order to hear sound from
the internal speakers.
I am not hearing the radio station.
o Remove your 1/8" (3.5 mm) cable from the Line In before going to Tuner mode in order to hear the radio
station.
6