Tabla de contenido
Installation Steps
Rear Bracket Installation
Install bracket as shown. Place one washer on either
side of the bracket, then insert the bolt through the front
hole with the washer and fasten the nut.
H
K
M
1
Front Bracket Installation
Put washer on the bolt and insert the bolt through the
hole in the bracket, and into the threaded insert of the
front post. Tighten with a 10 MM wrench.
2
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
J
Same process for the drivers side as the passenger side.
D
Push pin until it pops in place.
I
N
L
Page 3 of 8
Tabla de contenido
