Smanos SMK-500 Manual De Instrucciones página 7

EN
8. The steps to open the battery cover and to install the battery are
listed as follows:
(1) To power smoke detector requires a battery.
(2) Match terminals on the end(s) of the battery with opposite
terminal connections on the detector. Be sure to insert the
zinc-manganese dry battery in the position shown on the detector.
(3) When terminals are properly matched, push battery firmly in
until it snaps and cannot be shaken loose.
CAUTION: This smoke detector comes with cover latches that will prevent
the smoke detector cover from closing if battery is not installed. This tells you
that the smoke detector will not work until a new battery is properly installed.
The battery is purposely positioned WRONGLY in the factory to keep it fresh
until installation. It must be re-positioned correctly to provide DC power.
NOTE : When the detectory battery first makes contact with the detector, the
alarm horn may sound for one second. This is normal and indicates that the
battery is positioned properly. Close cover, then press the test button, holding
it down for about 5 seconds until the horn sounds. The horn should sound a
loud, pulsating alarm. This means the unit is working properly.
Connect with Alarm Control Panel
SMK-500 can not only work as a single station, but also can work
with alarm control panel to form an alarm system when wireless
module is added to the smoke detector.
1) Make sure the control panel is in learning state.
2) Press the testing button on the smoke detector for 3 seconds,
two beeps are heard. Simultaneously, one beep is heard from the
control panel. The detector has been connected successfully with
the control panel.
Testing:
Press the testing button on the smoke detector for 3 seconds, the
control panel will alarm immediately.
EN